
16 | Rinnai Heating Specication Guide 02-13
Condensate trap
Code = ESCONDK
Required for any vertical installations to
ensure condensate generated during
combustion is trapped and prevented
from entering the combustion
chamber of the heater. Supplied with
a drain tube (not pictured). Typically
only needed for through-wall vertical
extension flueing installations.
N.B: The condensate trap is included
with the ESKIT03.
Back spacer kits
Codes:
• ESBSKD Back spacer kit for Energysaver 1004FTR
• ESBSKE Back spacer kit for Energysaver 309FT
• ESBSKF Back spacer kit for Energysaver 559FT
• ESBSKG Back spacer kit for Energysaver 561FT
The back spacer kit covers the flue elbow connection and provides
the required clearances from the heater and wall in down and out,
and sideways (front-of-wall) horizontal flueing installations.
The back spacer kit is used INSTEAD of the rear panels supplied
with each Energysaver and adds approximately 115 mm of additional
depth (standard rear panel = 85 mm, back spacer panel = 200 mm).
Back spacer kit contents:
• Left spacer panel
• Right spacer panel
• Top spacer panel
• Flue elbow connection
• Plastic edging seal
The plastic edging seal is used to provide a protective edge
around the flue pipe cut-out in the side spacer panel (front-of-wall
horizontal flue installations only).
Steel flue guard
Code = R1370
Protection against hot flue gases when
the flue terminates low to the ground.
Colour - warm white.
Elbow adaptor
Code = ESELBOWB
For horizontal, and down and out
installations that are recessed into the
wall and that DO NOT require a back
spacer kit.
Requires a minimum clearance of
25 mm from combustible materials.
approx. 155 mm
561FT Energysaver with back
spacer kit
309FT Energysaver with
standard rear panels
200 mm
85 mm
Comentários a estes Manuais