Rinnai Elevate Manual de Instalação descarregar pdf (Página 37)

Rinnai Australia 34 Sapphire Operation & Installation Manual

HEATER ENGINE INSTALLATION - ZERO CLEARANCE

Step 3. Fitting Zero Clearance Box Into Cavity

Slide zero clearance box assembly into the cavity, ensuring

the gas and electricity supplies are accessible.

Secure the zero clearance into the cavity with

appropriate fasteners (not supplied).

Install the Rinnai rigid flue system components in

accordance with the ‘Flueing Installation Manual For Rinnai

Flamefire Heaters’ that is provided with the flue kit.

Step 4. Unpack The Heater Engine

The heater engine is supplied in one carton, check to

ensure you have all contents as listed on “BEFORE YOU

START” on page 2 at the start of this manual before

proceeding.

Remove carton by removing the straps and carefully lifting

the carton off the appliance. Remove all packaging

materials and check all components for damage. If ANY

damage is evident DO NOT install or operate this appliance.

Contact your supplier for advice.

Before installing the heater, check it is labelled for the

correct gas type, (refer to the gas type label on the top body

panel of the heater). Refer to the local gas authority for

confirmation of gas type if you are in doubt.

Step 5. Preparing Heater Engine

Drill 4 x Ø 3.2mm holes in the pre pressed location dimples

in the top panel of the heater. Then attach the flue guide

rails using these holes with four screws (supplied).

When preparing a cavity / frame for a zero

clearance installation the total cavity depth

MUST also include the thickness of the

external cladding , as the zero clearance

box MUST BE installed flush with the cladding

surface, failure to do this will cause

misalignment of the flueing.

Ensure there are no wall studs, noggins,

ceiling joists, wiring or other obstruction

within the wall and or ceiling cavity where the

flue is proposed to penetrate.

Retain the card board carton for use in the

“Positioning the Heater Engine” on page 35.

Flue guide rails and pop rivets supplied with

Zero Clearance kit, part number R2340.

Before proceeding any further with the heater

engine installation ensure the cladding for the

front of the enclosure has been fitted

Drill

4 x Ø 3.2mm

Holes

CAUTION

IMPORTANT

HINT

IMPORTANT

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Comentários a estes Manuais

Sem comentários

Rinnai Elevate Manual de Instalação Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Lareiras Rinnai Elevate