Rinnai Elevate Manual de Instalação descarregar pdf (Página 22)

Rinnai Australia 19 Sapphire Operation & Installation Manual

CARE AND MAINTENANCE

Your heater needs very little maintenance, but the following information will help you to keep it looking good and

working efficiently.

SERVICE

Rinnai recommend that this appliance and installation be inspected and serviced every 2 years or more frequently.

If the power supply cord or any other component of the heater are damaged, they must be replaced by Rinnai or

a suitably qualified person.

Any service or repair work should only be carried out by an authorised person. Rinnai has service and spare parts

departments nationally. See back cover for contact details.

TROUBLE SHOOTING

General Operation Characteristics

DO NOT attempt to clean the heater while the appliance is hot or operating.

All parts of the heater can be cleaned using a soft, damp cloth.

DO NOT use solvents or abrasives to clean any parts.

DO NOT spray aerosols in the vicinity of the heater whilst in operation.

DO NOT place articles on or against this heater.

DO NOT store flammable materials near this heater.

Service calls for general cleaning, maintenance and wear and tear are not necessarily covered

under the warranty. Service calls of this nature may be chargeable.

Faults caused by insufficient gas supply, gas quality, installation errors or operation errors are not

covered by the Rinnai warranty. Refer to separate Warranty Card for details.

Before asking for a service call please check the following table as these characteristics are part

of the normal operation of the appliance and do not indicate a fault.

CHARACTERISTIC EXPLANATION

At ignition:

Warm air does not start when the burner

lights.

The fan is started automatically after a short delay. This is to

allow the heat exchanger to warm up, helping to avoid cold

draughts.

This is normal operation.

Smoke or strange smells are produced on

the first start up after installation.

This is caused by grease, oil or dust on the heat exchanger.

This is to be expected and will cease after a short time.

Sharp clicking noises at ignition, or when

the unit thermostat modulates to a lower

or higher setting, or shuts down.

This is simply expansion and contraction noise from the heat

exchanger.

This is a normal operation sound.

During combustion:

Dull clunking noise when the thermostat

operates.

This is the sound of the solenoid gas valves opening and

closing to regulate the gas flow.

These are normal operation noises.

When the appliance is turned off:

Convection fan continues to run after

turning ‘OFF’.

This is to remove residual heat from the heat exchanger and

stops once the appliance cools sufficiently.

IMPORTANT

NOTE

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Comentários a estes Manuais

Sem comentários

Rinnai Elevate Manual de Instalação Página 22

Comentários a estes Manuais

Manuais e produtos relacionados com Lareiras Rinnai Elevate